[5-15-B] SS304 Flat Head Cap Screw

89 items。🔍 Filter in the interactive catalog

About this category

304 stainless countersunk screws with a hex socket, combining a flush finish with higher tightening torque - a socket drive is far less prone to cam-out than a cross recess, which suits jigs, tooling and mechanisms that need clamping without protrusion. 2-10 mm thread, 3-55 mm long, plus a few 316.

Standards DIN 7991 · ISO 10642

How to choose

• A countersunk head is thinner than a cap head and still takes less torque than a cap screw of the same size.
• Match the countersink angle (usually 90 degrees) or only the edge takes load.
• Stainless galls against stainless, more so in small threads - use anti-seize.

Specifications at a glance

This category lists 89 items. Size and material coverage below — all stocked in Taiwan.